Posted: Tue Feb 16, 2021 3:22 pm
In a few months Nick is going to realize he just built a whole new amp by replacing every part in his Marshall.
ShortScale.org
Rocking Short Scale Guitars Since 2006
https://www.shortscale.org/
Marshall JTM60 10 years on
Page 2 of 2
Posted: Tue Feb 16, 2021 4:14 pm
Well that OPT does look a bit small for a 60W amp, I doubt if it does much below 100 Hz.
Posted: Tue Feb 16, 2021 4:33 pm
Then he can sell them for like 5000Ls each, with a tonewood chassis and amber switch tipsplopswagon wrote:In a few months Nick is going to realize he just built a whole new amp by replacing every part in his Marshall.
Posted: Tue Feb 16, 2021 4:43 pm
Trigger's broom amp!plopswagon wrote:In a few months Nick is going to realize he just built a whole new amp by replacing every part in his Marshall.
Posted: Tue Feb 16, 2021 5:00 pm
Well, with those >>metal foil resistors<< costing £18.23 each how else can I make a profit?kingkiller wrote:Then he can sell them for like 5000Ls each, with a tonewood chassis and amber switch tips
Posted: Tue Feb 16, 2021 5:05 pm
I thought metal foil resistors were antivaxxers
Posted: Thu Feb 25, 2021 3:05 pm
Update: addressing the overheating issue.
1. Add heat deflector
2. Wire socket to heater DC supply
3. Cable tie fan to cage and connect to socket
All these changes are reversible, no drilling involved.
1. Add heat deflector
- jtm60-Heat_deflector.jpg (157.82 KiB) Viewed 559 times
- jtm60-fan_wire.jpg (98 KiB) Viewed 559 times
- jtm60-fan_wiring.jpg (220.55 KiB) Viewed 559 times